Prep. for Fittings & Deck Prep. for Fittings & Deck step 1, the hull has been turned over and is supported on a cradle. Prep. for Fittings & Deck step 2, showing how nose frame will be tidied up. Prep. for Fittings & Deck step 6.b & 6.c, Mast Step Support, showing ply along keel, vertical ply and additional supports. Prep. for Fittings & Deck step 8, Side Chainplates, 6 mm ply pad fitted to the inner surface of the side of the hull for reinforcing. Prep. for Fittings & Deck step 10.a, showing the reinforcing pad for the transom pintles. Prep. for Fittings & Deck step 10.c, drilling the holes for the transom pintles. Prep. for Fittings & Deck step 10.c, transom pintles fitted. Prep. for Fittings & Deck step 10.c, transom pintles interior shot. Prep. for Fittings & Deck step 11 & 12, showing anchor blocks for hiking straps in the foreground and the anchor blocks for the mainsheet track behind that. Prep. for Fittings & Deck step 13.a, drain plug Prep. for Fittings & Deck, drain plug drilled as per 13.a and note the deck stringers glued in place as per step 7 Prep. for Fittings & Deck completed, all epoxied and ready for the deck. This marks the end of the Prep. for Fittings & Deck section. Share this:TwitterFacebookLike Loading...